Cakewalk Sonar - 8.5 Betriebsanweisung PDF herunterladen (Seite 25)

Starting SONAR

When Wave Profiler determines the kind of card you have, always accept the default settings.

Setting up the MIDI In and MIDI Out devices

When you start SONAR for the first time, it checks your computer to find all the MIDI input and

output devices you have installed (such as sound cards and MIDI interfaces). However, sometimes

you need to tell SONAR exactly which devices you want it to use. If you’re not getting sound from

your sound card or MIDI keyboard, or if you just want to change the MIDI outputs and devices that

you are using, follow the steps in this section.

Choose Options > MIDI Devices to open a dialog box in which you select the MIDI In and MIDI Out

devices that SONAR will use. Each item in the list is a MIDI Input or MIDI Output from drivers

installed using the Windows Control Panel.

1. Select Options > MIDI Devices. You will see the MIDI Devices dialog box, which lets you choose

instruments on MIDI inputs and outputs.

Figure 4. The MIDI Devices dialog

2. Look at the top window. Notice that it shows devices on MIDI Inputs; make sure that all devices in

this window are checked. If a device isn’t checked, click on it once to select it for MIDI Input.

3. Look at the window on the bottom. Notice that it shows devices on MIDI Outputs. SONAR

numbers its MIDI Outputs by the order of the devices in this window. The device on top is on

Output 1, the one below it is on Output 2, and so on.

Note: You can run the Wave Profiler again at a later time (for example, if you install a new

sound card or driver) by choosing the Options > Audio General tab command and clicking

Wave Profiler.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 177 178

Keine Kommentare

Cakewalk Sonar - 8.5 Betriebsanweisung Seite 25